MOT Results

Honest John Good Garage Guide MOT Results » Peugeot » 306 » 1996

Peugeot 306 MOT Results

Registered in 1996
56.1% pass rate
from 358 tests in 2021
(21% worse than other 1996 cars)
More MoT Results
Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 1996 cars and highlighted areas where the Peugeot 306 is unusually good or bad.

  • 19% fail on Brakes (73% worse than other 1996 cars)
    • 16% fail on Brake performance (130% worse than other 1996 cars)
      • 10% fail on Service Brake Efficiency (sp) (2 times worse than other 1996 cars)
        • 10% fail on Rbt (sp) (2 times worse than other 1996 cars)
          • 5.6% fail on Service brake imbalance (2 times worse than other 1996 cars)
          • 5.3% fail on Service brake performance (2 times worse than other 1996 cars)
      • 7.3% fail on Parking brake efficiency (sp) (150% worse than other 1996 cars)
        • 7.0% fail on Rbt (sp) (160% worse than other 1996 cars)
        • 0.28% fail on Decelerometer (sp)
      • 4.7% fail on Service brake performance
        • 4.7% fail on Rbt (94% worse than other 1996 cars)
          • 3.9% fail on Service brake performance
          • 1.1% fail on Service brake imbalance
      • 3.4% fail on Parking brake performance (2 times worse than other 1996 cars)
        • 3.4% fail on Rbt (2 times worse than other 1996 cars)
          • 2.8% fail on Parking brake performance (2 times worse than other 1996 cars)
          • 0.28% fail on Parking (secondary brake performance)
          • 0.28% fail on Parking brake efficiency (Trikes, quads and pre-68 vehicles)
    • 2.5% fail on Rigid brake pipes
    • 1.4% fail on Service brake pedal or hand lever
      • 1.1% fail on Hand lever (4 times worse than other 1996 cars)
      • 0.28% fail on Pedal
    • 1.4% fail on Mechanical brake components
      • 0.56% fail on Brake linings and pads
        • 0.56% fail on Brake pads
      • 0.56% fail on Brake discs and drums
        • 0.56% fail on Brake discs
      • 0.28% fail on Brake cables, rods, levers and linkages
        • 0.28% fail on Cable
    • 0.84% fail on Parking brake control
      • 0.84% fail on Lever
    • 0.84% fail on Load sensing valves (4 times worse than other 1996 cars)
    • 0.56% fail on Air and vacuum systems
      • 0.28% fail on Pressure/vacuum build up
      • 0.28% fail on Leaks
    • 0.56% fail on Flexible brake hoses
    • 0.28% fail on Hydraulic systems
      • 0.28% fail on Reservoirs
    • 0.28% fail on Brake actuators (including spring brakes or hydraulic cylinders)
      • 0.28% fail on Hydraulic brake cylinder
  • 16% fail on Lamps, reflectors and electrical equipment
    • 5.3% fail on Direction indicators (100% worse than other 1996 cars)
      • 5.3% fail on Flashing type (100% worse than other 1996 cars)
        • 3.9% fail on Side repeaters (3 times worse than other 1996 cars)
        • 1.7% fail on Individual direction indicators
        • 0.28% fail on All direction indicators
    • 4.5% fail on Headlamp aim
      • 3.9% fail on Headlamp aim
      • 0.56% fail on Headlamp aim not tested
    • 3.4% fail on Front and rear fog lamps
      • 3.4% fail on Rear fog lamp
        • 3.4% fail on Rear fog lamp
    • 3.1% fail on Headlamps
      • 2.8% fail on Headlamp
      • 0.28% fail on Headlamp levelling device
    • 3.1% fail on Stop lamp
    • 0.84% fail on Electrical equipment
      • 0.56% fail on Horn
      • 0.28% fail on Battery(ies)
    • 0.56% fail on Registration plate lamp(s)
    • 0.28% fail on Hazard warning
      • 0.28% fail on Switch
    • 0.28% fail on Mandatory tell-tales
      • 0.28% fail on Rear fog lamp tell-tale
  • 15% fail on Suspension
    • 5.6% fail on Suspension arms
      • 2.5% fail on Pins and bushes
      • 2.0% fail on Ball joint
      • 0.84% fail on Ball joint dust cover
      • 0.56% fail on Attachment bracket and mounting (5 times worse than other 1996 cars)
    • 3.9% fail on Anti-roll bars (110% worse than other 1996 cars)
      • 2.2% fail on Linkage ball joint dust cover (6 times worse than other 1996 cars)
      • 0.84% fail on Linkage ball joints
      • 0.28% fail on Linkage
      • 0.28% fail on Ball joint
      • 0.28% fail on Ball joint dust cover
    • 3.4% fail on Wheel bearings (120% worse than other 1996 cars)
    • 2.8% fail on Component mounting prescribed areas
    • 2.0% fail on Sub-frames (2 times worse than other 1996 cars)
      • 1.7% fail on Sub-frame mounting prescribed areas (3 times worse than other 1996 cars)
      • 0.56% fail on Sub-frame
    • 0.84% fail on Other suspension component
      • 0.84% fail on Ball joint (3 times worse than other 1996 cars)
    • 0.56% fail on Axles
      • 0.28% fail on Swivel joints/housing
      • 0.28% fail on Swivel pins and bushes
    • 0.56% fail on Springs
      • 0.28% fail on Coil springs
        • 0.28% fail on Coil spring
      • 0.28% fail on Spring mounting prescribed areas
    • 0.56% fail on Shock absorbers
  • 10% fail on Visibility
    • 7.3% fail on Washers (100% worse than other 1996 cars)
    • 4.2% fail on Wipers
    • 0.28% fail on Bonnet
  • 7.8% fail on Body, chassis, structure
    • 2.2% fail on Exhaust system
    • 2.2% fail on Transmission
      • 2.2% fail on Drive shafts
        • 2.2% fail on Joints
    • 0.84% fail on Integral vehicle structure
      • 0.84% fail on Integral vehicle structure condition
    • 0.84% fail on Doors
      • 0.56% fail on Front passenger's door
        • 0.56% fail on Door condition
      • 0.28% fail on Other passenger's door
        • 0.28% fail on Door condition
    • 0.56% fail on Chassis
      • 0.56% fail on Chassis condition
    • 0.28% fail on Fuel system
      • 0.28% fail on Fuel cap/sealing device
    • 0.28% fail on Bumpers
    • 0.28% fail on Spare wheel
      • 0.28% fail on Carrier
    • 0.28% fail on Engine mounting
      • 0.28% fail on Engine mounting condition
    • 0.28% fail on Floor
    • 0.28% fail on Seats
      • 0.28% fail on Driver's seat
  • 5.6% fail on Noise, emissions and leaks
    • 5.3% fail on Exhaust emissions
      • 4.2% fail on Spark ignition
        • 3.9% fail on Catalyst emissions
        • 0.28% fail on Emissions not tested
      • 1.1% fail on Compression ignition
        • 0.28% fail on Pre 01/07/2008 Turbo
        • 0.28% fail on Pre 01/07/2008 Non turbo
        • 0.28% fail on On or after 01/07/2008
        • 0.28% fail on Emissions not tested
    • 0.56% fail on Fluid leaks
      • 0.56% fail on Engine oil leaks
  • 3.9% fail on Steering
    • 3.6% fail on Steering linkage components
      • 3.4% fail on Track rod end (120% worse than other 1996 cars)
      • 0.28% fail on Locking devices
    • 0.28% fail on Steering gear
      • 0.28% fail on Steering rack
  • 3.6% fail on Seat belts and supplementary restraint systems
    • 2.8% fail on Seat belts
      • 2.0% fail on Prescribed areas
      • 0.84% fail on Condition
    • 1.1% fail on SRS malfunction indicator lamp
  • 3.6% fail on Tyres
    • 2.2% fail on Tread depth
    • 1.7% fail on Condition
  • 2.0% fail on Identification of the vehicle
    • 2.0% fail on Registration plates
  • 0.28% fail on Road Wheels
    • 0.28% fail on Condition

Search Good Garages