Volkswagen Corrado MOT Results
Registered in 199073.8% pass rate
from 65 tests in 2021
More MoT Results
Failure rates by item
Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 1990 cars and highlighted areas where the Volkswagen Corrado is unusually good or bad.
-
15% fail on
Lamps, reflectors and electrical equipment
-
6.2% fail on
Headlamp aim
- 3.1% fail on Headlamp aim
- 3.1% fail on Headlamp aim not tested (8 times worse than other 1990 cars)
-
6.2% fail on
Electrical equipment
- 4.6% fail on Horn
- 1.5% fail on Battery(ies)
-
4.6% fail on
Headlamps
- 4.6% fail on Headlamp
-
3.1% fail on
Direction indicators
-
3.1% fail on
Flashing type
- 3.1% fail on Side repeaters
- 1.5% fail on All direction indicators
- 1.5% fail on Individual direction indicators
-
3.1% fail on
Flashing type
- 3.1% fail on Registration plate lamp(s)
-
1.5% fail on
Position lamps
- 1.5% fail on Position lamp
- 1.5% fail on Stop lamp
-
1.5% fail on
Mandatory tell-tales
- 1.5% fail on Main beam tell-tale
-
6.2% fail on
Headlamp aim
-
12% fail on
Brakes
-
7.7% fail on
Brake performance
-
4.6% fail on
Service brake performance
-
4.6% fail on
Rbt
- 4.6% fail on Service brake performance
-
4.6% fail on
Rbt
-
3.1% fail on
Parking brake efficiency (sp)
- 3.1% fail on Rbt (sp)
-
1.5% fail on
Service Brake Efficiency (sp)
-
1.5% fail on
Rbt (sp)
- 1.5% fail on Service brake imbalance
-
1.5% fail on
Rbt (sp)
-
1.5% fail on
Parking brake performance
-
1.5% fail on
Rbt
- 1.5% fail on Parking brake performance
-
1.5% fail on
Rbt
-
4.6% fail on
Service brake performance
- 4.6% fail on Load sensing valves (24 times worse than other 1990 cars)
-
3.1% fail on
Mechanical brake components
-
1.5% fail on
Brake linings and pads
- 1.5% fail on Brake pads
-
1.5% fail on
Brake cables, rods, levers and linkages
- 1.5% fail on Linkage
-
1.5% fail on
Brake linings and pads
-
7.7% fail on
Brake performance
-
9.2% fail on
Body, chassis, structure
-
4.6% fail on
Transmission
-
4.6% fail on
Drive shafts
- 4.6% fail on Joints
-
4.6% fail on
Drive shafts
- 3.1% fail on Exhaust system
-
1.5% fail on
Integral vehicle structure
- 1.5% fail on Integral vehicle structure condition
-
4.6% fail on
Transmission
-
7.7% fail on
Suspension
- 4.6% fail on Wheel bearings
- 3.1% fail on Component mounting prescribed areas
-
1.5% fail on
Springs
-
1.5% fail on
Coil springs
- 1.5% fail on Coil spring
-
1.5% fail on
Coil springs
-
1.5% fail on
Suspension arms
- 1.5% fail on Ball joint
-
1.5% fail on
Anti-roll bars
- 1.5% fail on Linkage pins and bushes
-
6.2% fail on
Visibility
- 4.6% fail on Wipers
- 1.5% fail on Washers
-
4.6% fail on
Noise, emissions and leaks
-
4.6% fail on
Exhaust emissions
-
3.1% fail on
Spark ignition
- 3.1% fail on Non catalyst emissions
-
1.5% fail on
Compression ignition
- 1.5% fail on Pre 01/07/2008 Turbo
-
3.1% fail on
Spark ignition
-
4.6% fail on
Exhaust emissions
-
3.1% fail on
Steering
-
1.5% fail on
Steering gear
- 1.5% fail on Steering rack
-
1.5% fail on
Power steering
- 1.5% fail on Operation
-
1.5% fail on
Steering gear
-
3.1% fail on
Tyres
- 1.5% fail on Condition
- 1.5% fail on Tread depth