Toyota Lucida MOT Results

Registered in 1996
54.0% pass rate
from 239 tests in 2020
Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 1996 cars and highlighted areas where the Toyota Lucida is unusually good or bad.

  • 25% fail on Lamps, reflectors and electrical equipment (61% worse than other 1996 cars)
    • 12% fail on Front and rear fog lamps (3 times worse than other 1996 cars)
      • 12% fail on Rear fog lamp (3 times worse than other 1996 cars)
        • 12% fail on Rear fog lamp (3 times worse than other 1996 cars)
        • 0.42% fail on Switch
    • 4.6% fail on Headlamps
      • 4.6% fail on Headlamp
    • 3.8% fail on Position lamps
      • 3.8% fail on Position lamp
    • 3.8% fail on Stop lamp
    • 3.3% fail on Headlamp aim
      • 3.3% fail on Headlamp aim
    • 3.3% fail on Registration plate lamp(s)
    • 2.9% fail on Electrical equipment
      • 2.1% fail on Battery(ies)
      • 0.84% fail on Horn
    • 1.3% fail on Mandatory tell-tales (4 times worse than other 1996 cars)
      • 1.3% fail on Rear fog lamp tell-tale (5 times worse than other 1996 cars)
    • 0.84% fail on Direction indicators
      • 0.84% fail on Flashing type
        • 0.42% fail on Individual direction indicators
        • 0.42% fail on Side repeaters
  • 17% fail on Brakes
    • 7.1% fail on Brake performance
      • 3.3% fail on Service brake performance
        • 3.3% fail on Rbt
          • 3.3% fail on Service brake performance
          • 0.42% fail on Service brake imbalance
      • 2.9% fail on Parking brake efficiency (sp)
        • 2.1% fail on Rbt (sp)
        • 0.84% fail on Decelerometer (sp)
      • 2.1% fail on Parking brake performance
        • 2.1% fail on Rbt
          • 1.3% fail on Parking (secondary brake performance) (6 times worse than other 1996 cars)
          • 0.84% fail on Parking brake performance
      • 0.42% fail on Brake performance not tested
      • 0.42% fail on Service Brake Efficiency (sp)
        • 0.42% fail on Rbt (sp)
          • 0.42% fail on Service brake imbalance
    • 5.0% fail on Mechanical brake components (140% worse than other 1996 cars)
      • 4.2% fail on Brake linings and pads (2 times worse than other 1996 cars)
        • 4.2% fail on Brake pads (2 times worse than other 1996 cars)
      • 2.1% fail on Brake discs and drums
        • 2.1% fail on Brake discs
      • 0.42% fail on Brake cables, rods, levers and linkages
        • 0.42% fail on Cable
    • 2.9% fail on Service brake pedal or hand lever (4 times worse than other 1996 cars)
      • 2.1% fail on Pedal (6 times worse than other 1996 cars)
      • 0.84% fail on Hand lever
    • 2.5% fail on Rigid brake pipes
    • 1.7% fail on Load sensing valves (7 times worse than other 1996 cars)
    • 0.84% fail on Parking brake control
      • 0.84% fail on Lever
    • 0.84% fail on Flexible brake hoses
    • 0.42% fail on Brake actuators (including spring brakes or hydraulic cylinders)
      • 0.42% fail on Hydraulic brake callipers
    • 0.42% fail on Other components and prescribed areas
      • 0.42% fail on Additional braking device
  • 14% fail on Suspension
    • 6.3% fail on Anti-roll bars (150% worse than other 1996 cars)
      • 2.5% fail on Linkage ball joint dust cover (5 times worse than other 1996 cars)
      • 1.3% fail on Pins and bushes
      • 1.3% fail on Linkage ball joints
      • 1.3% fail on Ball joint dust cover (5 times worse than other 1996 cars)
      • 0.42% fail on Linkage pins and bushes
    • 5.9% fail on Component mounting prescribed areas
    • 5.0% fail on Shock absorbers (2 times worse than other 1996 cars)
    • 0.84% fail on Macpherson strut
      • 0.42% fail on Macpherson strut
      • 0.42% fail on Attachment bracket and mounting
    • 0.42% fail on Suspension arms
      • 0.42% fail on Ball joint
  • 14% fail on Body, chassis, structure
    • 5.9% fail on Exhaust system
    • 5.4% fail on Transmission
      • 5.0% fail on Drive shafts
        • 4.2% fail on Joints
        • 0.42% fail on Drive shaft
        • 0.42% fail on Flexible couplings
      • 0.42% fail on Prop shafts
        • 0.42% fail on Prop shaft
    • 0.84% fail on Integral vehicle structure
      • 0.84% fail on Integral vehicle structure condition
    • 0.84% fail on Chassis
      • 0.84% fail on Chassis condition
    • 0.84% fail on Bumpers
    • 0.84% fail on Seats
      • 0.84% fail on Driver's seat
    • 0.42% fail on Fuel system
      • 0.42% fail on Pipe
    • 0.42% fail on Spare wheel
      • 0.42% fail on Carrier
    • 0.42% fail on Towbar
      • 0.42% fail on Vehicle structure
    • 0.42% fail on Boot lid
      • 0.42% fail on Boot lid condition
  • 12% fail on Noise, emissions and leaks
    • 10% fail on Exhaust emissions
      • 9.2% fail on Compression ignition (9 times worse than other 1996 cars)
        • 6.7% fail on Pre 01/07/2008 Turbo (14 times worse than other 1996 cars)
        • 2.5% fail on Emissions not tested (7 times worse than other 1996 cars)
        • 0.42% fail on Pre 01/07/2008 Non turbo
        • 0.42% fail on On or after 01/07/2008
      • 2.1% fail on Spark ignition (69% better than other 1996 cars)
        • 1.3% fail on Catalyst emissions (77% better than other 1996 cars)
        • 0.42% fail on Emission control equipment
          • 0.42% fail on Other emission control equipment
        • 0.42% fail on Non catalyst emissions
        • 0.42% fail on Emissions not tested
    • 2.1% fail on Fluid leaks
      • 2.1% fail on Engine oil leaks
  • 9.2% fail on Visibility
    • 6.3% fail on Wipers
    • 2.9% fail on Washers
    • 0.84% fail on View to rear
      • 0.84% fail on Mirrors
  • 4.6% fail on Tyres
    • 2.9% fail on Tread depth
    • 1.7% fail on Condition
    • 0.42% fail on Size/type
  • 2.9% fail on Steering
    • 1.3% fail on Power steering
      • 0.84% fail on Operation (5 times worse than other 1996 cars)
      • 0.42% fail on Other components
    • 0.84% fail on Steering gear
      • 0.84% fail on Steering rack
    • 0.84% fail on Steering linkage components
      • 0.42% fail on Ball joint
      • 0.42% fail on Track rod end
    • 0.42% fail on Steering column
  • 2.1% fail on Seat belts and supplementary restraint systems
    • 2.1% fail on Seat belts
      • 1.7% fail on Condition
      • 0.42% fail on Requirements
  • 1.7% fail on Identification of the vehicle
    • 1.7% fail on Registration plates
  • 1.7% fail on Road Wheels (4 times worse than other 1996 cars)
    • 1.7% fail on Attachment (6 times worse than other 1996 cars)

Search Good Garages