MOT Results

Honest John Good Garage Guide MOT Results » Toyota » Corolla » 1992

Toyota Corolla MOT Results

Registered in 1992
67.4% pass rate
from 224 tests in 2021
More MoT Results
Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 1992 cars and highlighted areas where the Toyota Corolla is unusually good or bad.

  • 12% fail on Suspension
    • 5.4% fail on Component mounting prescribed areas
    • 2.7% fail on Anti-roll bars
      • 0.89% fail on Pins and bushes
      • 0.45% fail on Attachment bracket and mounting
      • 0.45% fail on Ball joint
      • 0.45% fail on Linkage ball joints
      • 0.45% fail on Linkage ball joint dust cover
    • 1.8% fail on Shock absorbers
    • 1.8% fail on Suspension arms
      • 0.89% fail on Suspension arm
      • 0.45% fail on Pins and bushes
      • 0.45% fail on Ball joint dust cover
    • 0.89% fail on Wheel bearings
    • 0.89% fail on Springs
      • 0.89% fail on Coil springs
        • 0.89% fail on Coil spring
  • 11% fail on Lamps, reflectors and electrical equipment
    • 5.8% fail on Stop lamp (120% worse than other 1992 cars)
    • 2.2% fail on Headlamp aim
      • 1.8% fail on Headlamp aim
      • 0.45% fail on Headlamp aim not tested
    • 1.8% fail on Headlamps
      • 0.89% fail on Headlamp
      • 0.89% fail on Headlamp levelling device (8 times worse than other 1992 cars)
    • 0.89% fail on Position lamps
      • 0.89% fail on Position lamp
    • 0.89% fail on Direction indicators
      • 0.89% fail on Flashing type
        • 0.89% fail on Individual direction indicators
    • 0.45% fail on Front and rear fog lamps
      • 0.45% fail on Rear fog lamp
        • 0.45% fail on Rear fog lamp
    • 0.45% fail on Registration plate lamp(s)
  • 6.3% fail on Brakes
    • 4.9% fail on Brake performance
      • 3.6% fail on Service Brake Efficiency (sp)
        • 3.6% fail on Rbt (sp)
          • 3.6% fail on Service brake imbalance
          • 1.3% fail on Service brake performance
      • 2.7% fail on Parking brake efficiency (sp)
        • 2.7% fail on Rbt (sp)
      • 1.8% fail on Service brake performance
        • 1.8% fail on Rbt
          • 1.3% fail on Service brake performance
          • 0.89% fail on Service brake imbalance
      • 1.8% fail on Parking brake performance
        • 1.8% fail on Rbt
          • 1.8% fail on Parking brake performance
    • 0.45% fail on Service brake pedal or hand lever
      • 0.45% fail on Hand lever
    • 0.45% fail on Rigid brake pipes
    • 0.45% fail on Brake actuators (including spring brakes or hydraulic cylinders)
      • 0.45% fail on Hydraulic brake callipers
    • 0.45% fail on Other components and prescribed areas
      • 0.45% fail on Other components
  • 6.3% fail on Visibility
    • 4.9% fail on Wipers
    • 1.3% fail on Washers
  • 6.3% fail on Noise, emissions and leaks
    • 6.3% fail on Exhaust emissions
      • 6.3% fail on Spark ignition
        • 4.0% fail on Catalyst emissions
        • 1.3% fail on Emissions not tested
        • 0.89% fail on Emission control equipment (7 times worse than other 1992 cars)
          • 0.45% fail on Oxygen sensor
          • 0.45% fail on Other emission control equipment
  • 5.8% fail on Body, chassis, structure
    • 1.8% fail on Exhaust system
    • 1.8% fail on Transmission
      • 1.8% fail on Drive shafts
        • 1.8% fail on Joints
    • 0.89% fail on Chassis
      • 0.89% fail on Chassis condition
    • 0.89% fail on Body
      • 0.89% fail on Panel (4 times worse than other 1992 cars)
    • 0.45% fail on Integral vehicle structure
      • 0.45% fail on Integral vehicle structure condition
    • 0.45% fail on Fuel system
      • 0.45% fail on Pipe
    • 0.45% fail on Bumpers
    • 0.45% fail on Engine mounting
      • 0.45% fail on Bracket
    • 0.45% fail on Doors
      • 0.45% fail on Driver's door
        • 0.45% fail on Door condition
  • 4.0% fail on Tyres
    • 3.1% fail on Tread depth (2 times worse than other 1992 cars)
    • 0.89% fail on Condition
  • 3.6% fail on Steering
    • 2.2% fail on Steering gear
      • 2.2% fail on Steering rack
    • 0.89% fail on Steering linkage components
      • 0.89% fail on Track rod end
    • 0.45% fail on Power steering
      • 0.45% fail on Operation
    • 0.45% fail on Steering wheel
  • 3.1% fail on Seat belts and supplementary restraint systems
    • 3.1% fail on Seat belts
      • 2.7% fail on Prescribed areas
      • 0.45% fail on Condition
  • 0.45% fail on Identification of the vehicle
    • 0.45% fail on Registration plates

Search Good Garages