Rover 200 MOT Results

Registered in 1993

64.0% pass rate

from 236 tests in 2021

More MoT Results

Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 1993 cars and highlighted areas where the Rover 200 is unusually good or bad.

12% fail on Body, chassis, structure
- 4.7% fail on Transmission
  - 4.7% fail on Drive shafts
    - 4.7% fail on Joints
- 4.2% fail on Exhaust system
- 1.7% fail on Integral vehicle structure
  - 1.7% fail on Integral vehicle structure condition
- 0.85% fail on Fuel system
  - 0.42% fail on Tank
  - 0.42% fail on Fuel cap/sealing device
- 0.85% fail on Boot lid (18 times worse than other 1993 cars)
  - 0.85% fail on Boot lid condition (21 times worse than other 1993 cars)
- 0.42% fail on Chassis
  - 0.42% fail on Chassis condition
- 0.42% fail on Body
  - 0.42% fail on Other body component
10% fail on Suspension
- 4.2% fail on Component mounting prescribed areas
- 3.8% fail on Suspension arms
  - 1.3% fail on Pins and bushes
  - 1.3% fail on Ball joint
  - 0.85% fail on Ball joint dust cover
  - 0.42% fail on Attachment bracket and mounting
- 1.3% fail on Anti-roll bars
  - 0.85% fail on Linkage pins and bushes
  - 0.42% fail on Attachment bracket and mounting
- 1.3% fail on Sub-frames
  - 0.85% fail on Sub-frame (5 times worse than other 1993 cars)
  - 0.42% fail on Sub-frame mounting prescribed areas
- 0.42% fail on Wheel bearings
9.3% fail on Noise, emissions and leaks
- 9.3% fail on Exhaust emissions
  - 8.5% fail on Spark ignition
    - 6.4% fail on Catalyst emissions
    - 2.1% fail on Emissions not tested
    - 0.42% fail on Non catalyst emissions
  - 0.85% fail on Compression ignition
    - 0.85% fail on Pre 01/07/2008 Non turbo (7 times worse than other 1993 cars)
- 0.42% fail on Fluid leaks
  - 0.42% fail on Engine oil leaks
8.9% fail on Lamps, reflectors and electrical equipment
- 2.5% fail on Headlamp aim
  - 2.5% fail on Headlamp aim
- 1.7% fail on Headlamps
  - 1.7% fail on Headlamp
- 1.7% fail on Stop lamp
- 1.3% fail on Direction indicators
  - 1.3% fail on Flashing type
    - 0.85% fail on Individual direction indicators
    - 0.42% fail on Side repeaters
- 1.3% fail on Registration plate lamp(s)
- 0.85% fail on Electrical equipment
  - 0.42% fail on Battery(ies)
  - 0.42% fail on Horn
- 0.42% fail on Front and rear fog lamps
  - 0.42% fail on Rear fog lamp
    - 0.42% fail on Rear fog lamp
6.4% fail on Visibility
- 5.1% fail on Wipers
- 1.3% fail on Washers
4.2% fail on Brakes (62% better than other 1993 cars)
- 3.8% fail on Brake performance
  - 3.0% fail on Service Brake Efficiency (sp)
    - 3.0% fail on Rbt (sp)
      - 2.1% fail on Service brake performance
      - 0.85% fail on Service brake imbalance
  - 1.7% fail on Parking brake efficiency (sp)
    - 1.7% fail on Rbt (sp)
  - 0.42% fail on Service brake performance
    - 0.42% fail on Rbt
      - 0.42% fail on Service brake performance
      - 0.42% fail on Service brake imbalance
  - 0.42% fail on Parking brake performance
    - 0.42% fail on Rbt
      - 0.42% fail on Parking brake performance
- 0.42% fail on Service brake pedal or hand lever
  - 0.42% fail on Hand lever
- 0.42% fail on Mechanical brake components
  - 0.42% fail on Brake linings and pads
    - 0.42% fail on Brake pads
3.4% fail on Tyres
- 2.1% fail on Tread depth
- 1.3% fail on Condition
2.5% fail on Steering
- 1.7% fail on Steering linkage components
  - 1.3% fail on Track rod end
  - 0.42% fail on Locking devices
- 0.85% fail on Steering gear
  - 0.85% fail on Steering rack
2.5% fail on Seat belts and supplementary restraint systems
- 2.5% fail on Seat belts
  - 2.1% fail on Prescribed areas
  - 0.42% fail on Condition
0.85% fail on Identification of the vehicle
- 0.85% fail on Registration plates