Mitsubishi Delica / L300 / L400 MOT Results

Registered in 2000

54.8% pass rate

from 84 tests in 2020

More MoT Results

Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 2000 cars and highlighted areas where the Mitsubishi Delica / L300 / L400 is unusually good or bad.

23% fail on Lamps, reflectors and electrical equipment
- 13% fail on Front and rear fog lamps (8 times worse than other 2000 cars)
  - 13% fail on Rear fog lamp (8 times worse than other 2000 cars)
    - 13% fail on Rear fog lamp (8 times worse than other 2000 cars)
    - 1.2% fail on Switch
- 4.8% fail on Stop lamp
- 3.6% fail on Headlamp aim
  - 3.6% fail on Headlamp aim
- 2.4% fail on Position lamps
  - 2.4% fail on Position lamp
- 2.4% fail on Direction indicators
  - 2.4% fail on Flashing type
    - 2.4% fail on Individual direction indicators
- 2.4% fail on Electrical equipment
  - 2.4% fail on Horn
- 1.2% fail on Headlamps
  - 1.2% fail on Headlamp
- 1.2% fail on Registration plate lamp(s)
20% fail on Suspension
- 8.3% fail on Suspension arms
  - 6.0% fail on Ball joint
  - 1.2% fail on Suspension arm
  - 1.2% fail on Pins and bushes
- 8.3% fail on Component mounting prescribed areas
- 4.8% fail on Anti-roll bars
  - 2.4% fail on Linkage ball joints
  - 1.2% fail on Pins and bushes
  - 1.2% fail on Ball joint
  - 1.2% fail on Linkage ball joint dust cover
- 1.2% fail on Wheel bearings
- 1.2% fail on Springs
  - 1.2% fail on Leaf springs
    - 1.2% fail on Shackle pins and bushes
- 1.2% fail on Sub-frames
  - 1.2% fail on Sub-frame mounting prescribed areas
18% fail on Brakes
- 8.3% fail on Rigid brake pipes
- 6.0% fail on Brake performance
  - 3.6% fail on Service brake performance
    - 3.6% fail on Rbt
      - 3.6% fail on Service brake performance
  - 3.6% fail on Brake performance not tested (9 times worse than other 2000 cars)
- 3.6% fail on Mechanical brake components
  - 3.6% fail on Brake linings and pads
    - 3.6% fail on Brake pads
- 1.2% fail on Parking brake control
  - 1.2% fail on Lever
- 1.2% fail on Brake actuators (including spring brakes or hydraulic cylinders)
  - 1.2% fail on Hydraulic brake callipers
- 1.2% fail on Load sensing valves
11% fail on Visibility
- 7.1% fail on Wipers
- 3.6% fail on Washers
11% fail on Body, chassis, structure
- 3.6% fail on Integral vehicle structure
  - 3.6% fail on Integral vehicle structure condition
- 3.6% fail on Chassis
  - 3.6% fail on Chassis condition
- 2.4% fail on Exhaust system
- 2.4% fail on Transmission
  - 1.2% fail on Drive shafts
    - 1.2% fail on Joints
  - 1.2% fail on Prop shafts
    - 1.2% fail on Bearing housing
- 2.4% fail on Floor (20 times worse than other 2000 cars)
- 1.2% fail on Bumpers
- 1.2% fail on Body
  - 1.2% fail on Other body component
- 1.2% fail on Boot lid
  - 1.2% fail on Boot lid condition
9.5% fail on Steering
- 4.8% fail on Steering linkage components
  - 4.8% fail on Track rod end
- 2.4% fail on Steering gear
  - 2.4% fail on Steering rack
- 2.4% fail on Steering play (17 times worse than other 2000 cars)
  - 2.4% fail on Steering rack (20 times worse than other 2000 cars)
- 1.2% fail on Power steering
  - 1.2% fail on Other components
3.6% fail on Noise, emissions and leaks
- 3.6% fail on Exhaust emissions
  - 2.4% fail on Spark ignition
    - 1.2% fail on Catalyst emissions
    - 1.2% fail on Emissions not tested
  - 1.2% fail on Compression ignition
    - 1.2% fail on Pre 01/07/2008 Turbo
3.6% fail on Tyres
- 3.6% fail on Tread depth
2.4% fail on Seat belts and supplementary restraint systems
- 2.4% fail on Seat belts
  - 1.2% fail on Prescribed areas
  - 1.2% fail on Condition