Land Rover Range Rover MOT Results

Registered in 1990
63.6% pass rate
from 242 tests in 2017
Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 1990 cars and highlighted areas where the Land Rover Range Rover is unusually good or bad.

  • 19% fail on Lamps, Reflectors and Electrical Equipment
    • 5.0% fail on Headlamp aim
    • 4.1% fail on Battery (150% worse than other 1990 cars)
    • 3.7% fail on Position lamps
      • 2.1% fail on Rear lamps
      • 1.7% fail on Front lamps
      • 0.41% fail on All position lamps
    • 3.7% fail on Registration plate lamp
    • 3.3% fail on Stop lamp
    • 3.3% fail on Direction indicators
      • 3.3% fail on Flashing type
        • 2.5% fail on Side repeaters
        • 0.83% fail on Tell tales
    • 2.9% fail on Headlamps
      • 2.9% fail on Headlamp
      • 0.83% fail on Headlamp defects which don't require an aim check on retest
        • 0.83% fail on Main beam 'tell-tale'
      • 0.41% fail on Headlamp defects which do require an aim check on retest
        • 0.41% fail on Main beam 'tell-tale'
    • 2.5% fail on Rear fog lamp
      • 2.1% fail on Fog lamp
      • 0.41% fail on Tell tale
    • 1.2% fail on Hazard warning
      • 0.83% fail on Lamp
      • 0.41% fail on Switch
    • 0.41% fail on Electrical wiring
    • 0.41% fail on Horn
    • 0.41% fail on Headlamp aim not tested
  • 16% fail on Brakes
    • 7.9% fail on Hydraulic systems
      • 6.6% fail on Components
        • 5.4% fail on Pipes
        • 0.83% fail on Hoses
        • 0.41% fail on Cylinders
        • 0.41% fail on Pump
      • 1.7% fail on Leaks
      • 0.41% fail on Brake fluid warning lamp
      • 0.41% fail on Operation
    • 7.9% fail on Brake performance
      • 3.3% fail on Service brake performance
      • 2.1% fail on Parking brake performance
      • 1.7% fail on Brake performance not tested (4 times worse than other 1990 cars)
      • 1.2% fail on Rear wheels
      • 0.83% fail on Front wheels
      • 0.83% fail on Brake operation (9 times worse than other 1990 cars)
      • 0.41% fail on Brake imbalance
    • 4.5% fail on Hub components (200% worse than other 1990 cars)
      • 2.5% fail on Brake discs (4 times worse than other 1990 cars)
      • 1.7% fail on Brake pads
      • 0.83% fail on Brake calipers
    • 3.7% fail on Prescribed areas (14 times worse than other 1990 cars)
      • 3.7% fail on Master cylinder/servo mounting (16 times worse than other 1990 cars)
    • 2.9% fail on ABS (7 times worse than other 1990 cars)
    • 1.2% fail on Parking brake
      • 1.2% fail on Condition
    • 0.41% fail on Service brake control components
      • 0.41% fail on Pedal
        • 0.41% fail on Anti-slip
    • 0.41% fail on Restricted movement
  • 14% fail on Body, Structure and General Items (190% worse than other 1990 cars)
    • 9.5% fail on Body condition (3 times worse than other 1990 cars)
    • 3.7% fail on Vehicle structure (180% worse than other 1990 cars)
      • 3.7% fail on Chassis (180% worse than other 1990 cars)
    • 1.7% fail on Doors
      • 1.2% fail on Passengers other
      • 0.41% fail on Passengers front
    • 1.7% fail on Seats
      • 1.7% fail on Drivers
    • 0.41% fail on Engine mountings
    • 0.41% fail on Load security
      • 0.41% fail on Tailgate
  • 12% fail on Suspension
    • 4.1% fail on Prescribed areas
      • 2.5% fail on Component mounting
      • 1.2% fail on Spring mounting
      • 0.41% fail on Subframe mounting
    • 3.3% fail on Wheel bearings
      • 2.5% fail on Front
      • 0.83% fail on Rear
    • 2.1% fail on Shock absorbers
      • 2.1% fail on Condition
    • 1.7% fail on Axles (5 times worse than other 1990 cars)
      • 1.7% fail on Swivel joints/housing (8 times worse than other 1990 cars)
    • 1.2% fail on Coil springs
      • 1.2% fail on Condition
    • 1.2% fail on Panhard rods (14 times worse than other 1990 cars)
      • 1.2% fail on Pins/bushes/ball joints (20 times worse than other 1990 cars)
    • 0.41% fail on Torsion bars
      • 0.41% fail on Attachment
    • 0.41% fail on Suspension arms
      • 0.41% fail on Pins/bushes/ball joints
    • 0.41% fail on Tie bars/rods
      • 0.41% fail on Pins/bushes/ball joints
    • 0.41% fail on Torque/reaction arms
      • 0.41% fail on Pins/bushes/ball joints
  • 9.5% fail on Seat Belts and Supplementary Restraint Systems (170% worse than other 1990 cars)
    • 9.5% fail on Seat belts (170% worse than other 1990 cars)
      • 7.4% fail on Prescribed areas (170% worse than other 1990 cars)
      • 1.2% fail on Requirements (6 times worse than other 1990 cars)
      • 0.83% fail on Condition
  • 9.5% fail on Exhaust, Fuel and Emissions
    • 4.5% fail on Exhaust system
    • 4.5% fail on Emissions
    • 2.5% fail on Fuel system
      • 1.2% fail on Pipe
      • 0.41% fail on Tank
      • 0.41% fail on Hose
      • 0.41% fail on System
    • 0.83% fail on Emissions not tested
  • 8.7% fail on Driver's view of the road
    • 5.8% fail on Wipers
    • 3.3% fail on Washers
    • 0.83% fail on Mirrors
  • 6.2% fail on Steering
    • 5.8% fail on Steering system
      • 2.5% fail on Drag link end (6 times worse than other 1990 cars)
      • 1.2% fail on Ball joint
      • 0.83% fail on Free play
        • 0.83% fail on Steering box (7 times worse than other 1990 cars)
      • 0.83% fail on Steering box
      • 0.83% fail on Track rod end
      • 0.41% fail on Intermediate drop arm
      • 0.41% fail on Steering damper
      • 0.41% fail on Steering arm
      • 0.41% fail on Other components
        • 0.41% fail on Steering pivot point
    • 1.2% fail on Steering operation (3 times worse than other 1990 cars)
    • 0.41% fail on Power steering
      • 0.41% fail on Other components
    • 0.41% fail on Prescribed areas
  • 2.5% fail on Tyres
    • 1.2% fail on Condition
    • 1.2% fail on Tread depth
    • 0.41% fail on Size/type
  • 1.2% fail on Registration plates and VIN
    • 1.2% fail on Registration plate
  • 0.41% fail on Towbars
    • 0.41% fail on Vehicle structure

Search Good Garages