Land Rover Range Rover MOT Results
Registered in 198870.1% pass rate
from 157 tests in 2021
More MoT Results
Failure rates by item
Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 1988 cars and highlighted areas where the Land Rover Range Rover is unusually good or bad.
-
10% fail on
Lamps, reflectors and electrical equipment
- 3.2% fail on Stop lamp
-
3.2% fail on
Direction indicators
-
3.2% fail on
Flashing type
- 1.9% fail on Side repeaters
- 1.3% fail on Individual direction indicators
-
3.2% fail on
Flashing type
-
3.2% fail on
Front and rear fog lamps
-
3.2% fail on
Rear fog lamp
- 3.2% fail on Rear fog lamp
-
3.2% fail on
Rear fog lamp
-
2.5% fail on
Headlamp aim
- 2.5% fail on Headlamp aim
- 1.9% fail on Registration plate lamp(s)
-
1.3% fail on
Headlamps
- 1.3% fail on Headlamp
-
0.64% fail on
Mandatory tell-tales
- 0.64% fail on Rear fog lamp tell-tale
-
0.64% fail on
Electrical equipment
- 0.64% fail on Battery(ies)
-
9.6% fail on
Brakes
-
5.7% fail on
Brake performance
-
4.5% fail on
Service Brake Efficiency (sp)
- 2.5% fail on Decelerometer (sp) (20 times worse than other 1988 cars)
-
1.9% fail on
Rbt (sp)
- 1.3% fail on Service brake performance
- 0.64% fail on Service brake imbalance
-
1.9% fail on
Parking brake efficiency (sp)
- 1.3% fail on Rbt (sp)
- 0.64% fail on Decelerometer (sp)
-
1.3% fail on
Parking brake performance
-
1.3% fail on
Rbt
- 1.3% fail on Parking (secondary brake performance) (6 times worse than other 1988 cars)
- 0.64% fail on Parking brake performance
-
0.64% fail on
Plate brake tester
- 0.64% fail on Parking (secondary brake performance)
-
1.3% fail on
Rbt
-
0.64% fail on
Service brake performance
-
0.64% fail on
Rbt
- 0.64% fail on Service brake performance
-
0.64% fail on
Rbt
-
4.5% fail on
Service Brake Efficiency (sp)
-
3.2% fail on
Mechanical brake components
(3 times worse than other 1988 cars)
-
2.5% fail on
Brake linings and pads
(4 times worse than other 1988 cars)
- 2.5% fail on Brake pads (4 times worse than other 1988 cars)
-
1.3% fail on
Brake discs and drums
- 1.3% fail on Brake discs
-
2.5% fail on
Brake linings and pads
(4 times worse than other 1988 cars)
- 2.5% fail on Rigid brake pipes
-
1.3% fail on
Other components and prescribed areas
(6 times worse than other 1988 cars)
-
1.3% fail on
Prescribed areas
(8 times worse than other 1988 cars)
- 1.3% fail on Master cylinder/servo mounting (13 times worse than other 1988 cars)
-
1.3% fail on
Prescribed areas
(8 times worse than other 1988 cars)
-
0.64% fail on
Service brake pedal or hand lever
- 0.64% fail on Pedal
- 0.64% fail on Flexible brake hoses
-
5.7% fail on
Brake performance
-
7.6% fail on
Visibility
- 5.1% fail on Washers
- 3.2% fail on Wipers
-
0.64% fail on
Condition of glass
- 0.64% fail on Windscreen
-
6.4% fail on
Body, chassis, structure
-
2.5% fail on
Integral vehicle structure
- 2.5% fail on Integral vehicle structure condition
-
1.3% fail on
Chassis
- 1.3% fail on Chassis condition
- 1.3% fail on Exhaust system
-
1.3% fail on
Body
- 1.3% fail on Mounting fixings (30 times worse than other 1988 cars)
-
1.3% fail on
Doors
-
1.3% fail on
Other passenger's door
- 1.3% fail on Door condition
-
1.3% fail on
Other passenger's door
-
0.64% fail on
Fuel system
- 0.64% fail on Pipe
-
0.64% fail on
Transmission
-
0.64% fail on
Prop shafts
- 0.64% fail on Prop shaft
-
0.64% fail on
Prop shafts
-
2.5% fail on
Integral vehicle structure
-
6.4% fail on
Noise, emissions and leaks
-
5.7% fail on
Exhaust emissions
-
5.1% fail on
Spark ignition
- 3.8% fail on Non catalyst emissions
- 0.64% fail on Catalyst emissions
- 0.64% fail on Emissions not tested
-
0.64% fail on
Compression ignition
- 0.64% fail on On or after 01/07/2008
-
5.1% fail on
Spark ignition
-
1.3% fail on
Fluid leaks
- 0.64% fail on Engine oil leaks
- 0.64% fail on Transmission oil leaks
-
5.7% fail on
Exhaust emissions
-
4.5% fail on
Steering
-
4.5% fail on
Steering linkage components
- 3.8% fail on Track rod end (190% worse than other 1988 cars)
- 0.64% fail on Ball joint
-
0.64% fail on
Steering gear
- 0.64% fail on Steering box
-
4.5% fail on
Steering linkage components
-
4.5% fail on
Suspension
- 1.3% fail on Wheel bearings
-
1.3% fail on
Suspension arms
- 0.64% fail on Pins and bushes
- 0.64% fail on Ball joint dust cover
-
1.3% fail on
Anti-roll bars
- 1.3% fail on Linkage pins and bushes
- 0.64% fail on Shock absorbers
-
0.64% fail on
Other suspension component
- 0.64% fail on Attachment bracket and mounting
- 0.64% fail on Component mounting prescribed areas
-
3.8% fail on
Seat belts and supplementary restraint systems
-
3.8% fail on
Seat belts
- 1.9% fail on Prescribed areas
- 1.3% fail on Condition
- 0.64% fail on Attachment
- 0.64% fail on Requirements
-
3.8% fail on
Seat belts
-
1.3% fail on
Identification of the vehicle
- 1.3% fail on Registration plates