MOT Results

Honest John Vans MOT Results » Citroen » C15 » 1991

Citroen C15 MOT Results

Registered in 1991
49.3% pass rate
from 67 tests in 2021
More MoT Results
Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 1991 vans and highlighted areas where the Citroen C15 is unusually good or bad.

  • 33% fail on Lamps, reflectors and electrical equipment (65% worse than other 1991 vans)
    • 18% fail on Headlamp aim (3 times worse than other 1991 vans)
      • 15% fail on Headlamp aim (2 times worse than other 1991 vans)
      • 3.0% fail on Headlamp aim not tested (8 times worse than other 1991 vans)
    • 10% fail on Direction indicators
      • 10% fail on Flashing type
        • 9.0% fail on Side repeaters (5 times worse than other 1991 vans)
        • 3.0% fail on Individual direction indicators
    • 9.0% fail on Headlamps
      • 9.0% fail on Headlamp
    • 6.0% fail on Front and rear fog lamps
      • 6.0% fail on Rear fog lamp
        • 6.0% fail on Rear fog lamp
    • 4.5% fail on Stop lamp
    • 3.0% fail on Hazard warning (5 times worse than other 1991 vans)
      • 3.0% fail on Switch (5 times worse than other 1991 vans)
    • 3.0% fail on Registration plate lamp(s)
    • 3.0% fail on Electrical equipment
      • 3.0% fail on Horn
  • 24% fail on Body, chassis, structure
    • 12% fail on Transmission
      • 12% fail on Drive shafts (180% worse than other 1991 vans)
        • 12% fail on Joints (180% worse than other 1991 vans)
    • 7.5% fail on Exhaust system
    • 4.5% fail on Integral vehicle structure
      • 4.5% fail on Integral vehicle structure condition
    • 4.5% fail on Chassis
      • 4.5% fail on Chassis condition
    • 3.0% fail on Fuel system
      • 1.5% fail on Tank
      • 1.5% fail on System
    • 3.0% fail on Body
      • 1.5% fail on Body condition
      • 1.5% fail on Mounting fixings
    • 1.5% fail on Doors
      • 1.5% fail on Driver's door
        • 1.5% fail on Door condition
  • 22% fail on Suspension
    • 15% fail on Component mounting prescribed areas
    • 7.5% fail on Suspension arms
      • 4.5% fail on Ball joint
      • 1.5% fail on Pins and bushes
      • 1.5% fail on Ball joint dust cover
    • 3.0% fail on Wheel bearings
    • 3.0% fail on Sub-frames (7 times worse than other 1991 vans)
      • 3.0% fail on Sub-frame mounting prescribed areas (8 times worse than other 1991 vans)
    • 1.5% fail on Anti-roll bars
      • 1.5% fail on Pins and bushes
  • 18% fail on Brakes
    • 13% fail on Brake performance
      • 10% fail on Service Brake Efficiency (sp)
        • 10% fail on Rbt (sp)
          • 6.0% fail on Service brake performance
          • 4.5% fail on Service brake imbalance
      • 4.5% fail on Service brake performance
        • 4.5% fail on Rbt
          • 3.0% fail on Service brake performance
          • 1.5% fail on Service brake imbalance
      • 3.0% fail on Parking brake efficiency (sp)
        • 3.0% fail on Rbt (sp)
      • 1.5% fail on Parking brake performance
        • 1.5% fail on Rbt
          • 1.5% fail on Parking brake performance
    • 4.5% fail on Other components and prescribed areas (10 times worse than other 1991 vans)
      • 4.5% fail on Prescribed areas (11 times worse than other 1991 vans)
        • 4.5% fail on Master cylinder/servo mounting (24 times worse than other 1991 vans)
        • 1.5% fail on Actuating linkage mounting
    • 3.0% fail on Service brake pedal or hand lever
      • 3.0% fail on Pedal
    • 3.0% fail on Load sensing valves
    • 1.5% fail on Air and vacuum systems
      • 1.5% fail on Servos
    • 1.5% fail on Parking brake control
      • 1.5% fail on Lever
    • 1.5% fail on Hydraulic systems
      • 1.5% fail on Servos
    • 1.5% fail on Rigid brake pipes
    • 1.5% fail on Mechanical brake components
      • 1.5% fail on Brake cables, rods, levers and linkages
        • 1.5% fail on Cable
  • 9.0% fail on Visibility
    • 9.0% fail on Washers
  • 7.5% fail on Seat belts and supplementary restraint systems
    • 7.5% fail on Seat belts
      • 7.5% fail on Prescribed areas
  • 4.5% fail on Noise, emissions and leaks
    • 3.0% fail on Exhaust emissions
      • 3.0% fail on Compression ignition
        • 1.5% fail on Pre 01/07/2008 Non turbo
        • 1.5% fail on Emissions not tested
    • 1.5% fail on Fluid leaks
      • 1.5% fail on Other leaks
  • 3.0% fail on Steering
    • 1.5% fail on Steering gear
      • 1.5% fail on Steering rack
    • 1.5% fail on Steering linkage components
      • 1.5% fail on Track rod end
  • 1.5% fail on Tyres
    • 1.5% fail on Size/type
    • 1.5% fail on Condition