Land Rover Defender 110 MOT Results

Registered in 1986
65.7% pass rate
from 300 tests in 2020
Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 1986 cars and highlighted areas where the Land Rover Defender 110 is unusually good or bad.

  • 19% fail on Lamps, reflectors and electrical equipment
    • 6.7% fail on Headlamp aim
      • 6.0% fail on Headlamp aim
      • 0.67% fail on Headlamp aim not tested
    • 5.3% fail on Front and rear fog lamps
      • 5.3% fail on Rear fog lamp
        • 4.7% fail on Rear fog lamp
        • 0.67% fail on Switch
    • 4.7% fail on Direction indicators
      • 4.7% fail on Flashing type
        • 3.0% fail on Individual direction indicators
        • 1.3% fail on Side repeaters
        • 0.33% fail on Switch
    • 4.0% fail on Headlamps
      • 4.0% fail on Headlamp
    • 4.0% fail on Stop lamp
    • 3.7% fail on Electrical equipment
      • 3.0% fail on Horn
      • 0.67% fail on Trailer electrical socket (16 times worse than other 1986 cars)
    • 2.7% fail on Registration plate lamp(s)
    • 0.67% fail on Position lamps
      • 0.33% fail on Position lamp
      • 0.33% fail on Switch
    • 0.33% fail on Hazard warning
      • 0.33% fail on Switch
    • 0.33% fail on Rear reflectors
    • 0.33% fail on Mandatory tell-tales
      • 0.33% fail on Main beam tell-tale
  • 13% fail on Body, chassis, structure (50% worse than other 1986 cars)
    • 3.7% fail on Exhaust system
    • 3.0% fail on Chassis
      • 2.7% fail on Chassis condition
      • 0.67% fail on Strengthening plate (16 times worse than other 1986 cars)
    • 2.3% fail on Transmission
      • 2.3% fail on Prop shafts (4 times worse than other 1986 cars)
        • 1.7% fail on Joints (3 times worse than other 1986 cars)
        • 0.67% fail on Prop shaft (5 times worse than other 1986 cars)
    • 1.7% fail on Fuel system
      • 0.67% fail on Tank
      • 0.67% fail on System
      • 0.33% fail on Pipe
    • 1.7% fail on Doors
      • 1.0% fail on Front passenger's door
        • 1.0% fail on Door condition
      • 0.67% fail on Driver's door
        • 0.67% fail on Door condition
    • 1.3% fail on Integral vehicle structure
      • 1.3% fail on Integral vehicle structure condition
    • 0.67% fail on Towbar
      • 0.33% fail on Other towbar components
      • 0.33% fail on Vehicle structure
    • 0.67% fail on Body
      • 0.67% fail on Other body component
    • 0.67% fail on Floor
    • 0.67% fail on Seats
      • 0.67% fail on Driver's seat
    • 0.67% fail on Cabs (10 times worse than other 1986 cars)
      • 0.67% fail on Prescribed areas (10 times worse than other 1986 cars)
    • 0.33% fail on Bumpers
    • 0.33% fail on Engine mounting
      • 0.33% fail on Bracket
  • 12% fail on Brakes
    • 6.0% fail on Brake performance
      • 2.3% fail on Service brake performance
        • 2.0% fail on Rbt
          • 2.0% fail on Service brake performance
          • 0.67% fail on Service brake imbalance
        • 0.33% fail on Decelerometer
          • 0.33% fail on Service brake performance
      • 2.3% fail on Service Brake Efficiency (sp)
        • 1.3% fail on Rbt (sp)
          • 1.3% fail on Service brake imbalance
          • 0.33% fail on Service brake performance
        • 1.0% fail on Decelerometer (sp) (5 times worse than other 1986 cars)
      • 2.3% fail on Parking brake efficiency (sp)
        • 1.0% fail on Rbt (sp)
        • 1.0% fail on Decelerometer (sp) (3 times worse than other 1986 cars)
        • 0.33% fail on Gradient tester (sp)
    • 2.7% fail on Service brake pedal or hand lever (2 times worse than other 1986 cars)
      • 2.3% fail on Pedal (2 times worse than other 1986 cars)
      • 0.33% fail on Hand lever
    • 2.0% fail on Rigid brake pipes
    • 1.0% fail on Parking brake control
      • 1.0% fail on Lever
    • 1.0% fail on Brake actuators (including spring brakes or hydraulic cylinders)
      • 1.0% fail on Hydraulic brake cylinder (3 times worse than other 1986 cars)
    • 1.0% fail on Other components and prescribed areas
      • 1.0% fail on Prescribed areas
        • 0.67% fail on Master cylinder/servo mounting
        • 0.33% fail on Actuating linkage mounting
        • 0.33% fail on Other braking system component
    • 1.0% fail on Mechanical brake components
      • 0.67% fail on Brake discs and drums
        • 0.67% fail on Brake discs
      • 0.33% fail on Brake linings and pads
        • 0.33% fail on Brake pads
    • 0.67% fail on Hydraulic systems
      • 0.33% fail on Reservoirs
      • 0.33% fail on Valves
  • 8.7% fail on Visibility
    • 6.7% fail on Washers
    • 2.3% fail on Wipers
    • 0.33% fail on Driver's view
    • 0.33% fail on Bonnet
  • 8.3% fail on Steering (88% worse than other 1986 cars)
    • 6.7% fail on Steering linkage components (160% worse than other 1986 cars)
      • 3.0% fail on Track rod end
      • 2.7% fail on Drag link end (4 times worse than other 1986 cars)
      • 1.3% fail on Ball joint
      • 0.33% fail on Other components
        • 0.33% fail on Steering component
      • 0.33% fail on Locking devices
    • 1.7% fail on Power steering (2 times worse than other 1986 cars)
      • 1.0% fail on Other components (3 times worse than other 1986 cars)
      • 0.33% fail on Operation
      • 0.33% fail on Pipes and hoses
    • 0.33% fail on Steering gear
      • 0.33% fail on Steering box
    • 0.33% fail on Steering shaft
    • 0.33% fail on Steering coupling
      • 0.33% fail on Universal joint
    • 0.33% fail on Steering play
      • 0.33% fail on Steering box
  • 8.3% fail on Suspension
    • 3.0% fail on Suspension arms
      • 2.3% fail on Pins and bushes (2 times worse than other 1986 cars)
      • 0.33% fail on Ball joint
      • 0.33% fail on Ball joint dust cover
    • 2.3% fail on Component mounting prescribed areas
    • 1.3% fail on Wheel bearings
    • 1.0% fail on Anti-roll bars
      • 0.67% fail on Linkage pins and bushes
      • 0.33% fail on Anti-roll bar
      • 0.33% fail on Pins and bushes
    • 0.67% fail on Axles
      • 0.33% fail on King pins
      • 0.33% fail on Swivel pins and bushes
    • 0.67% fail on Suspension rods
      • 0.67% fail on Pins and bushes
    • 0.33% fail on Shock absorbers
    • 0.33% fail on Sub-frames
      • 0.33% fail on Ball joint
    • 0.33% fail on Other suspension component
      • 0.33% fail on Attachment bracket and mounting
  • 3.7% fail on Noise, emissions and leaks
    • 2.3% fail on Fluid leaks
      • 2.0% fail on Engine oil leaks
      • 0.33% fail on Transmission oil leaks
      • 0.33% fail on Other leaks
    • 1.7% fail on Exhaust emissions
      • 1.0% fail on Compression ignition
        • 0.33% fail on Pre 01/07/2008 Turbo
        • 0.33% fail on Pre 01/07/2008 Non turbo
        • 0.33% fail on Emissions not tested
      • 0.67% fail on Spark ignition (84% better than other 1986 cars)
        • 0.33% fail on Non catalyst emissions
        • 0.33% fail on Catalyst emissions
  • 2.0% fail on Seat belts and supplementary restraint systems
    • 2.0% fail on Seat belts
      • 0.67% fail on Prescribed areas
      • 0.67% fail on Condition
      • 0.33% fail on Attachment
      • 0.33% fail on Requirements
  • 1.3% fail on Tyres
    • 1.0% fail on Condition
    • 0.67% fail on Tread depth
  • 1.0% fail on Identification of the vehicle
    • 1.0% fail on Registration plates
  • 0.67% fail on Speedometer and speed limiter
    • 0.67% fail on Speedometer

Search Good Garages