Selling your classic car? It's FREE to list your car on Honest John Classics | No thanks

Audi 90 MOT Results

77.5% pass rate
from 89 tests in 2021
Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for pre-1990 cars and highlighted areas where the Audi 90 is unusually good or bad.

  • 10% fail on Lamps, reflectors and electrical equipment
    • 3.4% fail on Headlamps
      • 3.4% fail on Headlamp
    • 2.2% fail on Headlamp aim
      • 2.2% fail on Headlamp aim
    • 2.2% fail on Front and rear fog lamps
      • 2.2% fail on Rear fog lamp
        • 2.2% fail on Rear fog lamp
    • 1.1% fail on Direction indicators
      • 1.1% fail on Flashing type
        • 1.1% fail on Side repeaters
    • 1.1% fail on Registration plate lamp(s)
  • 9.0% fail on Brakes
    • 5.6% fail on Brake performance
      • 5.6% fail on Parking brake efficiency (sp)
        • 4.5% fail on Rbt (sp)
        • 1.1% fail on Decelerometer (sp)
      • 1.1% fail on Service brake performance
        • 1.1% fail on Rbt
          • 1.1% fail on Service brake performance
      • 1.1% fail on Service Brake Efficiency (sp)
        • 1.1% fail on Rbt (sp)
          • 1.1% fail on Service brake imbalance
      • 1.1% fail on Parking brake performance
        • 1.1% fail on Rbt
          • 1.1% fail on Parking brake performance
    • 2.2% fail on Rigid brake pipes
    • 1.1% fail on Load sensing valves
    • 1.1% fail on Mechanical brake components
      • 1.1% fail on Brake discs and drums
        • 1.1% fail on Brake discs
    • 1.1% fail on ABS / EBS / ESC
      • 1.1% fail on Anti-lock braking system
  • 6.7% fail on Suspension
    • 2.2% fail on Wheel bearings
    • 1.1% fail on Macpherson strut
      • 1.1% fail on Pins and bushes
    • 1.1% fail on Suspension arms
      • 1.1% fail on Ball joint
    • 1.1% fail on Anti-roll bars
      • 1.1% fail on Linkage ball joints
    • 1.1% fail on Sub-frames
      • 1.1% fail on Sub-frame
    • 1.1% fail on Component mounting prescribed areas
  • 5.6% fail on Visibility
    • 4.5% fail on Washers
    • 1.1% fail on Wipers
  • 4.5% fail on Body, chassis, structure
    • 1.1% fail on Integral vehicle structure
      • 1.1% fail on Integral vehicle structure condition
    • 1.1% fail on Exhaust system
    • 1.1% fail on Fuel system
      • 1.1% fail on Pipe
    • 1.1% fail on Transmission
      • 1.1% fail on Drive shafts
        • 1.1% fail on Joints
  • 1.1% fail on Speedometer and speed limiter
    • 1.1% fail on Speedometer
  • 1.1% fail on Noise, emissions and leaks
    • 1.1% fail on Exhaust emissions
      • 1.1% fail on Spark ignition
        • 1.1% fail on Non catalyst emissions