Land Rover Range Rover MOT Results

Registered in 1988
70.1% pass rate
from 157 tests in 2021
Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 1988 cars and highlighted areas where the Land Rover Range Rover is unusually good or bad.

  • 10% fail on Lamps, reflectors and electrical equipment
    • 3.2% fail on Stop lamp
    • 3.2% fail on Direction indicators
      • 3.2% fail on Flashing type
        • 1.9% fail on Side repeaters
        • 1.3% fail on Individual direction indicators
    • 3.2% fail on Front and rear fog lamps
      • 3.2% fail on Rear fog lamp
        • 3.2% fail on Rear fog lamp
    • 2.5% fail on Headlamp aim
      • 2.5% fail on Headlamp aim
    • 1.9% fail on Registration plate lamp(s)
    • 1.3% fail on Headlamps
      • 1.3% fail on Headlamp
    • 0.64% fail on Mandatory tell-tales
      • 0.64% fail on Rear fog lamp tell-tale
    • 0.64% fail on Electrical equipment
      • 0.64% fail on Battery(ies)
  • 9.6% fail on Brakes
    • 5.7% fail on Brake performance
      • 4.5% fail on Service Brake Efficiency (sp)
        • 2.5% fail on Decelerometer (sp) (20 times worse than other 1988 cars)
        • 1.9% fail on Rbt (sp)
          • 1.3% fail on Service brake performance
          • 0.64% fail on Service brake imbalance
      • 1.9% fail on Parking brake efficiency (sp)
        • 1.3% fail on Rbt (sp)
        • 0.64% fail on Decelerometer (sp)
      • 1.3% fail on Parking brake performance
        • 1.3% fail on Rbt
          • 1.3% fail on Parking (secondary brake performance) (6 times worse than other 1988 cars)
          • 0.64% fail on Parking brake performance
        • 0.64% fail on Plate brake tester
          • 0.64% fail on Parking (secondary brake performance)
      • 0.64% fail on Service brake performance
        • 0.64% fail on Rbt
          • 0.64% fail on Service brake performance
    • 3.2% fail on Mechanical brake components (3 times worse than other 1988 cars)
      • 2.5% fail on Brake linings and pads (4 times worse than other 1988 cars)
        • 2.5% fail on Brake pads (4 times worse than other 1988 cars)
      • 1.3% fail on Brake discs and drums
        • 1.3% fail on Brake discs
    • 2.5% fail on Rigid brake pipes
    • 1.3% fail on Other components and prescribed areas (6 times worse than other 1988 cars)
      • 1.3% fail on Prescribed areas (8 times worse than other 1988 cars)
        • 1.3% fail on Master cylinder/servo mounting (13 times worse than other 1988 cars)
    • 0.64% fail on Service brake pedal or hand lever
      • 0.64% fail on Pedal
    • 0.64% fail on Flexible brake hoses
  • 7.6% fail on Visibility
    • 5.1% fail on Washers
    • 3.2% fail on Wipers
    • 0.64% fail on Condition of glass
      • 0.64% fail on Windscreen
  • 6.4% fail on Body, chassis, structure
    • 2.5% fail on Integral vehicle structure
      • 2.5% fail on Integral vehicle structure condition
    • 1.3% fail on Chassis
      • 1.3% fail on Chassis condition
    • 1.3% fail on Exhaust system
    • 1.3% fail on Body
      • 1.3% fail on Mounting fixings (30 times worse than other 1988 cars)
    • 1.3% fail on Doors
      • 1.3% fail on Other passenger's door
        • 1.3% fail on Door condition
    • 0.64% fail on Fuel system
      • 0.64% fail on Pipe
    • 0.64% fail on Transmission
      • 0.64% fail on Prop shafts
        • 0.64% fail on Prop shaft
  • 6.4% fail on Noise, emissions and leaks
    • 5.7% fail on Exhaust emissions
      • 5.1% fail on Spark ignition
        • 3.8% fail on Non catalyst emissions
        • 0.64% fail on Catalyst emissions
        • 0.64% fail on Emissions not tested
      • 0.64% fail on Compression ignition
        • 0.64% fail on On or after 01/07/2008
    • 1.3% fail on Fluid leaks
      • 0.64% fail on Engine oil leaks
      • 0.64% fail on Transmission oil leaks
  • 4.5% fail on Steering
    • 4.5% fail on Steering linkage components
      • 3.8% fail on Track rod end (190% worse than other 1988 cars)
      • 0.64% fail on Ball joint
    • 0.64% fail on Steering gear
      • 0.64% fail on Steering box
  • 4.5% fail on Suspension
    • 1.3% fail on Wheel bearings
    • 1.3% fail on Suspension arms
      • 0.64% fail on Pins and bushes
      • 0.64% fail on Ball joint dust cover
    • 1.3% fail on Anti-roll bars
      • 1.3% fail on Linkage pins and bushes
    • 0.64% fail on Shock absorbers
    • 0.64% fail on Other suspension component
      • 0.64% fail on Attachment bracket and mounting
    • 0.64% fail on Component mounting prescribed areas
  • 3.8% fail on Seat belts and supplementary restraint systems
    • 3.8% fail on Seat belts
      • 1.9% fail on Prescribed areas
      • 1.3% fail on Condition
      • 0.64% fail on Attachment
      • 0.64% fail on Requirements
  • 1.3% fail on Identification of the vehicle
    • 1.3% fail on Registration plates

Search Good Garages