MOT Results

Honest John Good Garage Guide MOT Results » FIAT » X1/9 » 1988

FIAT X1/9 MOT Results

Registered in 1988
72.1% pass rate
from 61 tests in 2021
More MoT Results
Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 1988 cars and highlighted areas where the FIAT X1/9 is unusually good or bad.

  • 13% fail on Noise, emissions and leaks
    • 13% fail on Exhaust emissions (150% worse than other 1988 cars)
      • 11% fail on Spark ignition
        • 9.8% fail on Non catalyst emissions
        • 1.6% fail on Emissions not tested
      • 1.6% fail on Compression ignition
        • 1.6% fail on Emissions not tested
  • 9.8% fail on Brakes
    • 9.8% fail on Brake performance
      • 4.9% fail on Parking brake efficiency (sp)
        • 4.9% fail on Rbt (sp)
      • 3.3% fail on Service brake performance
        • 3.3% fail on Rbt
          • 1.6% fail on Service brake performance
          • 1.6% fail on Service brake imbalance
      • 1.6% fail on Service Brake Efficiency (sp)
        • 1.6% fail on Rbt (sp)
          • 1.6% fail on Service brake performance
      • 1.6% fail on Parking brake performance
        • 1.6% fail on Rbt
          • 1.6% fail on Parking brake performance
    • 1.6% fail on Mechanical brake components
      • 1.6% fail on Brake cables, rods, levers and linkages
        • 1.6% fail on Cable
  • 9.8% fail on Lamps, reflectors and electrical equipment
    • 4.9% fail on Headlamp aim
      • 3.3% fail on Headlamp aim
      • 1.6% fail on Headlamp aim not tested
    • 3.3% fail on Headlamps
      • 3.3% fail on Headlamp
    • 3.3% fail on Front and rear fog lamps
      • 3.3% fail on Rear fog lamp
        • 3.3% fail on Rear fog lamp
    • 1.6% fail on Stop lamp
    • 1.6% fail on Electrical equipment
      • 1.6% fail on Horn
  • 8.2% fail on Visibility
    • 3.3% fail on Wipers
    • 3.3% fail on Washers
    • 1.6% fail on Bonnet
  • 3.3% fail on Suspension
    • 1.6% fail on Wheel bearings
    • 1.6% fail on Other suspension component
      • 1.6% fail on Ball joint
    • 1.6% fail on Component mounting prescribed areas
  • 3.3% fail on Body, chassis, structure
    • 1.6% fail on Integral vehicle structure
      • 1.6% fail on Integral vehicle structure condition
    • 1.6% fail on Boot lid
      • 1.6% fail on Boot lid condition
  • 1.6% fail on Seat belts and supplementary restraint systems
    • 1.6% fail on Seat belts
      • 1.6% fail on Condition

Search Good Garages