MOT Results

Honest John Good Garage Guide MOT Results » Daihatsu » Fourtrak » 1992

Daihatsu Fourtrak MOT Results

Registered in 1992
57.6% pass rate
from 66 tests in 2021
More MoT Results
Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 1992 cars and highlighted areas where the Daihatsu Fourtrak is unusually good or bad.

  • 20% fail on Lamps, reflectors and electrical equipment
    • 7.6% fail on Front and rear fog lamps
      • 7.6% fail on Rear fog lamp
        • 7.6% fail on Rear fog lamp
    • 4.5% fail on Registration plate lamp(s)
    • 3.0% fail on Headlamps
      • 3.0% fail on Headlamp
    • 3.0% fail on Headlamp aim
      • 3.0% fail on Headlamp aim
    • 1.5% fail on Stop lamp
    • 1.5% fail on Rear reflectors
  • 15% fail on Body, chassis, structure
    • 6.1% fail on Chassis (4 times worse than other 1992 cars)
      • 6.1% fail on Chassis condition (4 times worse than other 1992 cars)
    • 4.5% fail on Integral vehicle structure
      • 4.5% fail on Integral vehicle structure condition
    • 3.0% fail on Fuel system
      • 1.5% fail on Pipe
      • 1.5% fail on Fuel cap/sealing device
    • 1.5% fail on Exhaust system
    • 1.5% fail on Body
      • 1.5% fail on Panel
  • 14% fail on Brakes
    • 7.6% fail on Brake performance
      • 4.5% fail on Service Brake Efficiency (sp)
        • 4.5% fail on Rbt (sp)
          • 3.0% fail on Service brake performance
          • 3.0% fail on Service brake imbalance
      • 4.5% fail on Parking brake efficiency (sp)
        • 4.5% fail on Rbt (sp)
      • 3.0% fail on Service brake performance
        • 3.0% fail on Rbt
          • 1.5% fail on Service brake performance
          • 1.5% fail on Service brake imbalance
    • 3.0% fail on Mechanical brake components
      • 3.0% fail on Brake linings and pads
        • 3.0% fail on Brake pads
    • 1.5% fail on Rigid brake pipes
    • 1.5% fail on Other components and prescribed areas
      • 1.5% fail on Prescribed areas
        • 1.5% fail on Master cylinder/servo mounting
  • 11% fail on Suspension
    • 4.5% fail on Component mounting prescribed areas
    • 1.5% fail on Axles
      • 1.5% fail on Swivel pins and bushes
    • 1.5% fail on Wheel bearings
    • 1.5% fail on Springs
      • 1.5% fail on Leaf springs
        • 1.5% fail on Fixings and fixing bolts
    • 1.5% fail on Anti-roll bars
      • 1.5% fail on Pins and bushes
  • 9.1% fail on Seat belts and supplementary restraint systems (2 times worse than other 1992 cars)
    • 9.1% fail on Seat belts (2 times worse than other 1992 cars)
      • 7.6% fail on Prescribed areas (3 times worse than other 1992 cars)
      • 1.5% fail on Condition
  • 4.5% fail on Steering
    • 1.5% fail on Steering gear
      • 1.5% fail on Operation
    • 1.5% fail on Steering linkage components
      • 1.5% fail on Track rod end
    • 1.5% fail on Power steering
      • 1.5% fail on Operation
  • 4.5% fail on Tyres
    • 3.0% fail on Condition
    • 1.5% fail on Tread depth
  • 3.0% fail on Visibility
    • 3.0% fail on Washers
  • 3.0% fail on Noise, emissions and leaks
    • 1.5% fail on Exhaust emissions
      • 1.5% fail on Compression ignition
        • 1.5% fail on Pre 01/07/2008 Turbo
    • 1.5% fail on Fluid leaks
      • 1.5% fail on Hydraulic fluid leaks

Search Good Garages